Instead, of using the decal, the surface can be milled or otherwise marked using a template that can be downloaded here. If you notice the decal coming off with it, please repeat step 6.
Similar to step 2, remove any air bubbles by firmly pressing against them with a flat edge.Īt a sharp angle, gently pull the transfer paper off of the decal. Place the decal on the surface, ensuring that it is flat, level and the correct orientation. If the decal appears to stick, repeat step 2. Peel the backing paper away from the decal. It is crucial that this is near on perfect as this is the method in which you locate the touch switch.
Prepare the decal by removing any air bubbles that might have formed via firmly rubbing the sheet with a smooth edge (squeegee/credit card).Įnsure that you have aligned the decal up to the touch surface. Please ensure that the surface is dry and warmer than 8 ° C. To fix the decal for the Touch Surface to your surface follow these steps:
LOXONE TOUCH TREE FREE
Please make sure that the surface is dry and free of grease.
LOXONE TOUCH TREE ACTIVATION KEY
With the included touch point decal sticker you can attach the 5 keys as well as the activation key of a touch surface on any smooth surface. The touch surface has five mounting points.īe sure to avoid any Air gap between the underside of the mounting surface and the Touch Surface. Screws: F or a reliable and durable assembly, we recommend the touch to be attached to the bottom surface with screws.
LOXONE TOUCH TREE HOW TO
Tree connections are required to get this device functioning, for more information on how to wire up Tree devices, please see the Wiring Loxone Tree page.Īdhesive: Using the supplied 3M adhesive strip, you can attach the touch surface on smooth oil-free surfaces directly without screws. The Touch Surface is best attached to the surface in question by screwing it to the underside.
The Touch Surface does not click when activated via the T6 key and no command is sent to the Miniserver when the touch is activated by T6. After activating, the Touch Surface will, every time you press the button (T1 – T6), send packets to the Miniserver. In this mode, all 6 touch points are always active and can be used at any time. On touch, a key-click is registered and forwarded to the Miniserver. Multi clicks are not supported.The activation process is to protect against any unintentional button presses such as leaning on a button when preparing food or spilling liquids onto the surface. This is done simply by pressing button 6 once, after 500ms (if no other button is touched during this time) the touch activates for 5 seconds (default time). During this time all keys (also key 6) can be used independently. Whenever a key is pressed during this time, the activation time is reset to 5 seconds. If no button is pressed for 5 seconds, the touch is deactivated again and must be reactivated via button 6 to continue use. The activation and its expiration time are visualised by means of the 5 LEDs counting down. This mode should be used when the Touch Surface is placed under tables, surfaces or kitchen tops. In this mode, the Touch Surface must be activated before it can be used.There are two modes of using the Touch Surface Air and by default, the surface is in the first of these listed below. These modes can be changed via Loxone Config in the touch surface periphery under the property “Activation necessary”. The surface being used must be non-conductive in order for the Touch Surface to function.
0 kommentar(er)
